Spice up your Arduino project with a beautiful large touchscreen display
shield with built in microSD card connection. This TFT display is big
(2.8" diagonal) bright (4 white-LED backlight) and colorful (18-bit
262,000 different shades)! 240x320 pixels with individual pixel control.
It has way more resolution than a black and white 128x64 display. As a
bonus, this display has a resistive touchscreen attached to it already,
so you can detect finger presses anywhere on the screen.
The shield is fully assembled, tested and ready to go. No wiring, no
soldering! Simply plug it in and load up our library - you'll have it
running in under 10 minutes!
Works best with any classic Arduino (UNO/Duemilanove/Diecimila). This shield does work with the Mega Arduinos but its going to be half the speed of the Uno-type boards
because of the way the Mega rearranges all the pins (there is no way to
get around this!) This shield is not Leonardo-compatible
This display shield has a controller built into it with RAM buffering,
so that almost no work is done by the microcontroller. The shield does
require a lot of pins: 12 lines total for the display, 13 total if you
use the microSD card
Of course, we
wouldn't just leave you with a datasheet and a "good luck!" - we've
written a full open source graphics library that can draw pixels, lines,
rectangles, circles and text. We also have a touch screen library that
detects x, y and z (pressure) and example code to demonstrate all of it.
The code is written for Arduino but can be easily ported to your
If you are not using an Arduino-shaped microcontroller, check out our 2.8" TFT breakout board which can be easily wired up to any processor
the breakout board version does not have microSD holder.