DHT11 basic temperature-humidity sensor + extras

5,47 EUR

incl. 19 % USt zzgl. Versandkosten

Gewicht: 0.0020 kg

Hersteller: Adafruit Industries

Lagerbestand: 0

Nicht auf Lager.

Nicht auf Lager.

Art.Nr.: ADA386
     

Produktbeschreibung

The DHT11 is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2 seconds, so when using our library, sensor readings can be up to 2 seconds old.
Compared to the DHT22, this sensor is less precise, less accurate and works in a smaller range of temperature/humidity, but its smaller and less expensive

Comes with a 4.7K or 10K resistor, which you will want to use as a pullup from the data pin to VCC.

Kunden kauften auch

Schrittmotor NEMA 8: Bipolar, 200 Steps, 20x30mm, 3.9V, 0.6A

Schrittmotor NEMA 8: Bipolar, 200 Steps, 20x30mm, 3.9V, 0.6A

20,23 EUR

Adafruit RGB Positive 16x2 LCD+Keypad Kit for Raspberry Pi

Adafruit RGB Positive 16x2 LCD+Keypad Kit for Raspberry Pi

26,99 EUR

mSD-Shield v1

mSD-Shield v1

17,49 EUR - 13,50 EUR

16x2 LCD gelb auf blau (serielle Ansteuerung 5V)

16x2 LCD gelb auf blau (serielle Ansteuerung 5V)

0,00 EUR

Arduino & Breadboard Halter

Arduino & Breadboard Halter

4,27 EUR