Adapter Satz zum Anschluss des BeagleBoards an den Flyswatter JTAG Debugger.
This kit provides adapter boards that enable the Flyswatter to interface with the BeagleBoard's JTAG and RS-232 headers.
JTAG Adapter Board - This
board plugs into the Flyswatter's 14-pin ARM JTAG connector and converts
the pins to a 14-pin header that is compatible with the BeagleBoard's
14-pin JTAG interface (TI Interface). The Adapter board uses the 14-pin
JTAG cable that comes with the Flyswatter.
RS-232 Adapter Board -
This board plugs into the Flyswatter's RS-232 connector and converts the
serial port pins into a 10-pin header that is compatible with the
BeagleBoard's 10-pin RS-232 interface.
10-pin Ribbon Cable - This cable is used to connect to the BeagleBoard's 10-pin RS-232 interface to the Flyswatter. Cable length = 8 inches.