Drucksensor für einen Bereich von 100g - 10kg. Der
Druck auf der Messfläche bewirkt eine Änderung des Widerstandes.
This is a force sensitive resistor with a square, 1.75x1.5", sensing
area. This FSR will vary its resistance depending on how much pressure
is being applied to the sensing area. The harder the force, the lower
the resistance. When no pressure is being applied to the FSR its
resistance will be larger than 1MΩ. This FSR can sense applied force
anywhere in the range of 100g-10kg.
Two pins extend from the bottom of the sensor with 0.1" pitch making it
bread board friendly. There is a peel-and-stick rubber backing on the
other side of the sensing area to mount the FSR.
These sensors are simple to set up and great for sensing pressure, but
they aren't incredibly accurate. Use them to sense if it's being
squeezed, but you may not want to use it as a scale.
Overall length: 3.5"
Overall width: 1.75"
Sensing area: 1.75x1.5"