|
38Khz IR Receiver38Khz IR Receiver für die E-Block Serie.
|
|
Camera ModuleThis USB Camera Module can stream images as large as 320x240 with up to 20fps on smaller images.
|
|
ChipworkX Development System.NET Micro Framwork ARM9 Entwicklungskit von GHI Electronics, das Kit baut auf dem ChipworkX Modul auf besitzt ein 4,3" LCD mit Touchscreen. 355,00 EUR incl. 19 % USt zzgl. Versandkosten
|
|
E-Block 3-Pin ShieldArduino / FEZ Shield für den Anschluss diverser 3-Pin E-Block Module. 16,96 EUR incl. 19 % USt zzgl. Versandkosten
|
|
eblock Expansion ModuleGHI's catalog is full of 3-pin eblocks. Those eblocks can be connected to any Gadgeteer mainboard using this extension. Note that you will need to use the drivers from the eblock page you are trying to use. 8,90 EUR incl. 19 % USt zzgl. Versandkosten
|
|
EMX Development System.NET Micro Framwork ARM7 Entwicklungskit von GHI Electronics, das Kit
baut auf dem EMX Modul auf besitzt ein 3,5" LCD mit Touchscreen.
|
|
EMX Module.NET Micro Framwork ARM7 Modul von GHI Electronics
|
|
Ethernet J11D ModuleThis Ethernet Module gives a Gadgeteer mainboard an instant access to networks and internet. Not all Ethernet modules work on all boards. Make sure this module is compatible with your mainboard. This module is compatible with GHI's Spider mainboard.
|
|
FEZ Cobra MainboardDas FEZ Cobra basierst auf dem EMX Module (72MHz ARM7 + 16MB Ram + 4,5MB Flash). 136,95 EUR incl. 19 % USt zzgl. Versandkosten
|
|
FEZ Connect ShieldFEZ Ethernt Shield mit dem WIZ5100 Chipsatz, zusätzlich bietet das Board 8 eblocks Steckverbinder, sowie ein Goldcap Kondensator der die RTC des FEZ Panda II bei Stromausfall weiter versorgt. 30,36 EUR incl. 19 % USt zzgl. Versandkosten
|
|
FEZ Hydra Basic KitBasis Kit enthält alles was zum Start mit dem FEZ Hydra nötig ist.
|
|
FEZ Mini Robot KitRoboter Bausatz mit dem FEZ mini als Controller. 86,82 EUR incl. 19 % USt zzgl. Versandkosten
|
|
FEZ Music ShieldDas FEZ Music Shield ist ein Aufsteckboard für die FEZ Panda (II), FEZ Domino oder die Arduino Boards. Auf dem Shield befindet sich der VLSI VS1053 Ogg Vorbis, MP3, AAC, WMA, FLAC und MIDI Decoder.
|
|
FEZ RhinoDas FEZ Rhino ist ein kleines OEM System mit dem USBizi144 Chipsatz, es lässt sich mit der freien Software Microsoft Visual C# Express programmieren. Es gibt schon viele fertige Bibliotheken für z.B. FAT System auf SD Karten, UART, SPI, I2C, GPIO, PWM, ADC, DAC 65,95 EUR incl. 19 % USt zzgl. Versandkosten
|
|
FEZ Rhino OEM BoxDas OEM Kit enthält neben dem FEZ Rhino:
|
|
FEZ Spider Starter KitShipping begins on Sep. 30, 2011
|
|
FEZ Touch2,4" LCD mit einer Auflösung von240x320 Pixeln.
|
|
FEZ Ultimate KitFEZ Ultimate Kit enthält:
|
|
I/O 40 ExtenderDer I/O Expander ist eine E-Block Erweiterung. Via dem I2C Bus stehen 40 Ein- bzw. Ausgänge zur Verfügung. Es sind bis zu 8 solcher Expander parallel möglich, damit stehen maximal 320 I/O zur Verfügung 25,46 EUR incl. 19 % USt zzgl. Versandkosten
|
|
IRLED TransmitterIRLED Transmitter für die E-Block Serie.
|
|
LED - gelb8mm LED für die E-Block Serie. 2,75 EUR incl. 19 % USt zzgl. Versandkosten
|
|
LED - grün8mm LED für die E-Block Serie. 2,75 EUR incl. 19 % USt zzgl. Versandkosten
|
|
LED - rot8mm LED für die E-Block Serie. 2,75 EUR incl. 19 % USt zzgl. Versandkosten
|
|
LichtsensorLichtsensor für die E-Block Serie.
|
|
Piezo (Lautsprecher)Piezo (Lautsprecher) für die E-Block Serie. 4,24 EUR incl. 19 % USt zzgl. Versandkosten
|
|
Pontentiometer - HorizontalPontentiometer für die E-Block Serie. 4,24 EUR incl. 19 % USt zzgl. Versandkosten
|
|
RelaisRelaismodul für die 3-Pin E-Block Serie von GHI. 12,74 EUR incl. 19 % USt zzgl. Versandkosten
|
|
SD Card ModulSD / MMC Kartenatapter für die GHI NETMF Boards.
|
|
Smart Multicolor LED Module (DaisyLink)This smart module includes a 32bit microcontroller. The stock firmware controls a bright multicolor LED (fade, blink,..) through .NET Gadgeteer DaysyLink protocol commands sent from .NET Gadgeteer mainboard. It also allows chaining with other DaisyLink modules. Advanced users may program or customize the on-board microcontroller. 13,75 EUR incl. 19 % USt zzgl. Versandkosten
|
|
Taster ModulButton Module for Gadgeteer-compatible devices. This module is equipted with an on-board configurable LED. 4,27 EUR incl. 19 % USt zzgl. Versandkosten
|
|
TemperatursensorNTC Temperatursensor für die E-Block Serie.
|
|
TinyCLR FEZ Cobra GehäuseKunststoffgehäuse für das FEZ Cobra + 3,5" LCD, mit einer Modifikation passt auch das 4,3" LCD. 22,75 EUR incl. 19 % USt zzgl. Versandkosten
|
|
TinyCLR FEZ Cobra OEM Box (3.5" Display)FEZ Cobra Kit incl.
220,00 EUR incl. 19 % USt zzgl. Versandkosten
|
|
TinyCLR FEZ Cobra OEM Box (4.3" Display)FEZ Cobra Kit incl.
265,00 EUR incl. 19 % USt zzgl. Versandkosten
|
|
TinyCLR FEZ DominoDas FEZ Domino ist ein kleines Eval System mit dem NXP LPC2388, es lässt
sich mit der freien Software Microsoft Visual C# Express programmieren.
Es gibt schon viele fertige Bibliotheken für z.B. FAT System auf SD
Karten, UART, SPI, I2C, GPIO, PWM, ADC, DAC
|
|
TinyCLR FEZ Micro-SD ErweiterungmicroSD Erweiterung für die FEZ Boards, das Modul ist fertig bestückt. 18,29 EUR incl. 19 % USt zzgl. Versandkosten
|
|
TinyCLR FEZ MiniDas FEZ Mini ist ein kleines Eval System mit dem NXP LPC2387, es lässt
sich mit der freien Software Microsoft Visual C# Express programmieren.
Es gibt schon viele fertige Bibliotheken für z.B. FAT System auf SD
Karten, UART, SPI, I2C, GPIO, PWM, ADC, DAC
|
|
TinyCLR FEZ PandaDas FEZ Panda ist ein kleines Eval System mit dem NXP LPC2387, es lässt
sich mit der freien Software Microsoft Visual C# Express programmieren.
Es gibt schon viele fertige Bibliotheken für z.B. FAT System auf SD
Karten, UART, SPI, I2C, GPIO, PWM, ADC, DAC
|
|
TinyCLR FEZ Panda IIErweiterte Version des bekannten FEZ Panda mit einer microSD Karte. Das Board kommt Mitte März auf den Markt. 36,59 EUR incl. 19 % USt zzgl. Versandkosten
|
|
TinyCLR FEZ WiFi ErweiterungWLan Erweiterung für die FEZ Boards auf Basis des ZeroG ZG2100 Modules.
|
|
uALFAT ChipsatzDas uALFAT ist ein ARM Controller mit integrierten FAT Dateisystem, dieser unterstützt das direkt Ánschlieen einer SD (microSD) Karte oder eines USB Speichers. Der Controller selbst kann über SPI/USART/I2C kommunizieren. 14,10 EUR incl. 19 % USt zzgl. Versandkosten
|
|
uALFAT MicroSD BoardDas uALFAT-TF ist ein OEM Modul mit dem GHI electronics uALFAT Chipsatz und einem microSD Sockel.
|
|
uALFAT SD BoardDas uALFAT-TF ist ein OEM Modul mit dem GHI electronics uALFAT Chipsatz und einem SD Sockel.
|
|
uALFAT USB BoardDas uALFAT-TF ist ein OEM Modul mit dem GHI electronics uALFAT Chipsatz und dem MAX3421 USB Host Controller.
|
|
USB Client DP ModuleThis module provides access to USB client connector and also includes an advanced power supply, allowing the mainboard to be powered from USB or from the power jack. Connecting power on both sides is safe. The power supply is fully functional from 7V to 30V supporting over 800mA of current. 21,51 EUR incl. 19 % USt zzgl. Versandkosten
|
|
USBizi100 ChipsatzUSBizi™ 100 pin chipset is identical to the 144 pin version except it
doesn't contain a USB host. USB device is still available and works
exactly the same way.
|
|
WiFi RS21 ModulWlan Erweiterung für die GHI NETMF Boards.
|