INA169 Analoger DC Stromsensor - 60V 5A Max

10,57 EUR

incl. 19 % USt zzgl. Versandkosten

Gewicht: 0.0040 kg

Hersteller: Adafruit Industries

Lagerbestand: 8

Lagernd, versandfertig in 24 Stunden.

Lagernd, versandfertig in 24 Stunden.

Art.Nr.: ADA1164
     

Produktbeschreibung

Breakout Board mit dem analogen INA169 Stromsensor.
Das Board ist für eine Spannung von bis zu 60V und einem Strom von 5A ausgelegt und gibt je 1A -> 1V Ausgangsspannung aus.
Das Verhältnis von Strom und Spannung kann durch ändern eines Widerstandes angepasst werden.

This breakout board will solve all your current-monitoring problems. Instead of struggling with a multimeter, you can just use the handy INA169 chip on this breakout to both measure both the DC current draw and have a handy analog output that is with respect to ground. The analog output makes this an ideal breakout for feedback-loop control.

Most current-measuring devices such as our current panel meter are only good for low side measuring. That means that unless you want to get a battery involved, you have to stick the measurement resistor between the target ground and true ground. This can cause problems with circuits since electronics tend to not like it when the ground references change and move with varying current draw. This chip is much smarter - it can handle high side current measuring, up to +60VDC!

A precision amplifier measures the voltage across the 0.1 ohm, 1% sense resistor. The resistor is rated for 2W continuous so you can measure up to +5A continuous. The output is a current that is drawn through the on-board 10K resistor so that the output voltage is 1V per Amp. So for 2A draw, the output will be 2V. You can change out the load resistor to be larger or smaller by cutting the traces next to it and soldering a thru hole resistor over. If you solder in a 20K resistor you'll get 2V per Amp, with a 5K resistor, 0.5V per Amp.

We include a 6-pin header (so you can easily attach this sensor to a breadboard) as well as a 3.5mm terminal plug so you can easily attach and detach your load. Usage is simple. Power the sensor with 2.7-60V, and connect V+ to the high side of your power supply, then connect V- to your grounded load. Then use a multimeter to measure the voltage output, that's it!

Kunden kauften auch

Schrittmotor NEMA 14: Bipolar, 200 Steps, 35x26mm, 7.4V, 0.28A

Schrittmotor NEMA 14: Bipolar, 200 Steps, 35x26mm, 7.4V, 0.28A

14,27 EUR

Solarzelle 37 x 33mm

Solarzelle 37 x 33mm

7,97 EUR

Simple Case für Raspberry Pi Zero - transparent

Simple Case für Raspberry Pi Zero - transparent

3,50 EUR

Raspberry Pi Kamera v1.3

Raspberry Pi Kamera v1.3

23,80 EUR

Arduino TFT LCD Screen

Arduino TFT LCD Screen

22,61 EUR