Metallgehäuse für Arduino Duemilanove, UNO, Mega

Produktbeschreibung

Dieses Metallghäuse von ESawdust ist für die Boards der Arduino Familie entwicklet wurden. Weiter unten gibt es ein Aufbauvideo zu dem Gehäuse.

Optional ist eine Deckplatte mit dem Ausschnitt für das Arduino Ethernet Shield erhältlich.

Finally, home-sweet-home for your Arduino projects!  Made from sturdy, lightweight powder-coated aluminum, the Crib for Arduino case can accommodate either an Arduino Duemilanove or Arduino Mega with head room to spare for a shield like an Ethernet shield.  This enclosure weighs only 5.6 oz (159 g) and is structurally very strong.

The baseplate is pre-drilled with hole patterns for both Arduino boards so you get perfect alignment and no hole drilling for board mounting.   

Flanges on the lid let you mount your project anywhere with just 4 screws - bolt it securely under your desk or to the ceiling!  Or just insert four rubber feet (not included) into the flange holes so your Arduino project can sit on your desk and not scratch it.

Finally, use the snap-in standoffs to quickly mount your board and go.

Crib for Arduino case comes with:

(1) pre-drilled baseplate

(1) lid

(1) blank faceplate

(1) Arduino faceplate

(10) self-drilling screws to secure the lid, base, and faceplates

(4) snap-in 3/16" standoffs for board mounting

Dimensions

Baseplate: 4.4" x 2.6"

Lid top, width: 2.72"

Lid base, width: 4.22" (base includes flanges)

Lid, length: 4.4"

Lid, height: 2.3"

Faceplates: 2.56" x 2.225"

Weight

5.6 oz (159 grams)

If you use the Ethernet Shield in your projects, we offer an optional Arduino Ethernet Shield faceplate that will bolt right on the front of the enclosure replacing the Arduino faceplate that comes with your Crib.   The faceplates are easy to drill so you can add switches, LEDs or other controls on the front panel.

Photos show Arduino, Arduino Mega, and Arduino with Ethernet Shield - none of these boards are included.   Ethernet Shield faceplate shown in some photos is optional, not included.

The following videos demonstrate the assembly of your Crib for Arduino case: