OpenSegment Serial Display - 20mm (Red)

18,01 EUR

incl. 19 % USt zzgl. Versandkosten

Gewicht: 0.0240 kg

Hersteller: SparkFun

Lagerbestand: 0

Nicht auf Lager.

Nicht auf Lager.

Art.Nr.: COM-11644
     

Produktbeschreibung

4x20mm 7-Segment LED Anzeige mit integriertem Treiber und einem ATmega328 (mit Arduino Bootloader) als Controller. Durch den onBoard Controller hat man die Möglichkeit diese LED Anzeige einfach via I2C, Uart oder SPI anzusteuern. Über den 6-poligen FTDI Anschluss lässt sich das Board recht einfach flashen.



OpenSegment makes it easy to add a large 7-segment display to your project. Because larger 7-segment displays pull more power than a microcontroller is able to drive directly, the OpenSegment has 8 PNP and 4 NPN transistors in order to drive the segments at their maximum brightness!

The on-board ATmega328 receives data over multiple digital interfaces (such as TWI, UART and SPI) and does all the PWM and upkeep of the display so your main controller doesn't have to. There are even two built-in functions that can be activated with solder jumpers. The counter function simply counts up or down, incrementing when you pull down SDO and decrementing when you pull down SDI. The meter function gives you a voltage read-out of the ADC!

OpenSegment runs at 5V and uses a standard FTDI connection for programming. The board is pre-flashed with a bootloader compatible with the Arduino Pro Mini @ 8MHz setting under the Arduino IDE. This firmware is an updated version of the Serial 7-Segment firmware designed to run on both devices. The commands will be largely the same except, of course, that this display only has decimals and no colon. See the datasheet for the Serial 7-Segment below to get an idea of the serial command set.

Features:

  • On-board Transistors Allow Display to Run at Full Brightness
  • Serial Commands Available to Adjust Brightness, Baud Rate, and I2C Address
  • Individual Control for Digits and Decimal Points
  • Arduino Compatible with FTDI Header
  • Built-in Meter and Counter functions

Documents:

COM-11644


Kunden kauften auch

Raspberry Pi 1 Modell B (ARM11, 512MB RAM)

Raspberry Pi 1 Modell B (ARM11, 512MB RAM)

31,95 EUR

RF Link Empfänger - 434MHz

RF Link Empfänger - 434MHz

5,41 EUR

RGB backlight negative LCD 16x2 + extras - RGB on black

RGB backlight negative LCD 16x2 + extras - RGB on black

15,64 EUR

Panasonic (Sanyo) eneloop Mignon AA 2000 mAh Akku NiMH - HR-3UTGB

Panasonic (Sanyo) eneloop Mignon AA 2000 mAh Akku NiMH - HR-3UTGB

2,10 EUR - 1,90 EUR

Licht/Frequenz Wandler - TSL235R

Licht/Frequenz Wandler - TSL235R

3,19 EUR