PIC32-T795H (PIC32 Entwicklungskit)

Produktbeschreibung

Kleines PIC32 Board von Olimex, ideal für die Verwendung auf Breadboards.

The special T-form of this board allow it to snap-on BREADBOARD-1 and supply directly the VCC and GND to Breadboard bus. Perfect for fast breadboarding with Jumper Wires

FEATURES:

• PIC32MX795F512H 80 Mhz microcontroller 512KB Flash 128KB RAM , 3x SPI, 4x I2C, USB OTG, 1MSPS ADC, PMP 80Mhz digital capture, 5 TIMERS/CCP, 53 GPIOs
• USB-OTG supporting both Host and Device function allow implementation of Google Android ADK
• UEXT connector which allow many existing modules like RF, ZIGBEE, GSM, GPS to be connected
• two LEDs
• one BUTTONs
• RESET button
• mini USB connector is used which is common and used in most cell phones, so you do not have to buy other cables
• all PIC ports available on 0.1" connectors
• ICSP connectorallos programming with PIC-KIT3
• Dimensions 87x54 mm (3.4x2.12")

DOCUMENTS:

• PIC32-T795 - User manual
• Duinomite User manual 1.03

HARDWARE:

• PIC32-T795 Rev_A schematic in PDF format
• PIC32-T795 Rev_B schematic in PDF format
• PIC32-T795 schematic Rev_B in Eagle format released under Creative Commons Attribution-Share Alike 3.0 United States License
• PIC32-T795 board Rev_B in Eagle format released under Creative Commons Attribution-Share Alike 3.0 United States License

WARNING:

Do not use "programmer-to-go" button when there is no image on the OLIMEX PIC-KIT3 or MICROCHIP PIC-KIT3 or that might put your microcontroller in an inrecoverable state. We have tested the mentioned scenario and we can confirm it destroys PIC32 chips (using both our and the original Microchip PICKIT3). We don't take responsibility if you brick your chip that way. For more info check the following: www.microchip.com/forums/m635420.aspx.

SOFTWARE:

• PINGUINO IDE supports PIC32MX795F512
• DUINOMITE firmware supports PIC32-T795 we ship PIC32-T795 by default with DUINOMITE firmware and bootloader