PIR Bewegungsmelder (JST)

10,76 EUR

incl. 19 % USt zzgl. Versandkosten

Gewicht: 0.0500 kg

Hersteller: SparkFun

Lagerbestand: 8

Lagernd, versandfertig in 24 Stunden.

Lagernd, versandfertig in 24 Stunden.

Art.Nr.: SEN-13285
     

Produktbeschreibung

Einfacher PIR Bewegungsmelder mit einem Versorgungsspannungsbereich von 12V DC.
Der Sensor besitzt einen Open-Collector Ausgang.

vollständige englische Beschreibung:

This is a simple to use motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the ‘alarm’ pin will go low.

This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire past the 5V regulator on board to make this unit work at 3.3V. Sensor uses 1.6mA@3.3V.

The alarm pin is an open collector meaning you will need a pull up resistor on the alarm pin. The open drain setup allows multiple motion sensors to be connected on a single input pin. If any of the motion sensors go off, the input pin will be pulled low.

We’ve finally updated the connector! Gone is the old “odd” connector, now you will find a common 3-pin JST! This makes the PIR Sensor much more accessible for whatever your project may need. Red = Power, White = Ground, and Black = Alarm.

Download: Datasheet

Kunden kauften auch

SMD-Klappbox - klein (10 Stück)

SMD-Klappbox - klein (10 Stück)

3,75 EUR - 3,15 EUR

5V / 1.2A Netzteil (1.3mm Stecker)

5V / 1.2A Netzteil (1.3mm Stecker)

Nur 2,38 EUR Statt 5,36 EUR

Arduino YUN

Arduino YUN

63,07 EUR

SSOP - DIP Adapter 16-Pin

SSOP - DIP Adapter 16-Pin

3,27 EUR