16x2 LCD schwarz auf grün (serielle Ansteuerung 5V)

26,99 EUR

incl. 19 % USt zzgl. Versandkosten

Gewicht: 0.0500 kg

Hersteller: SparkFun

Lagerbestand: 10

Lagernd, versandfertig in 24 Stunden.

Lagernd, versandfertig in 24 Stunden.

Art.Nr.: LCD-09393
     

Produktbeschreibung

Dieses 16x2 Zeichen Display besitzt eine Adapterplatine mit einem PIC16F88. Dieser empfängt die anzuzeigenden Daten über eine serielle Schnittstelle, damit benötigt man nur eine Datenleitung (nicht wie sonst üblich 6). Darüber hinaus lässt sich auch die LED Hintergrundbeleuchtung über den Controller ein-/ausschalten.


This is the latest evolution of our serial LCD. Included on a single board is a 16x2 LCD and an embedded circuit based around a PIC 16F88. The on-board PIC takes a TTL serial input and prints the characters it receives onto the LCD. The installed firmware also allows for a number of special commands so you can clear the screen, adjust the backlight brightness, turn the display on/off, and more.

Communication with SerLCD requires 5V TTL serial at a default baud rate of 9600bps (8-N-1). You can adjust the baud to any standard rate between 2400 and 38400bps. The power (VDD), ground (GND) and RX pins are all broken out to both a 0.1" pitch header as well as a 3-pin JST connector.

SerLCD has the ability to dim the backlight to conserve power if needed. There is also a potentiometer on the back of the display to adjust the contrast.

This LCD makes for a great gift, because it can be used for so many different projects! For more gift ideas check out the SparkFun Gift Guide!

Features:
  • Embedded PIC 16F88 utilizes onboard UART for greater communication accuracy
  • Adjustable baud rates of 2400, 4800, 9600 (default), 14400, 19200 and 38400
  • Operational Backspace
  • Greater processing speed at 10MHz
  • Incoming buffer stores up to 80 characters
  • Backlight transistor can handle up to 1A
  • Pulse width modulation of backlight allows direct control of backlight brightness and current consumption
  • All surface mount design allows a backpack that is half the size of the original
  • Faster boot-up time
  • Boot-up display can be turned on/off via firmware
  • User definable splash screen

Dimensions:

  • PCB: 103x36mm
  • LCD: 71.4x26.4mm

Documents:


Kunden kauften auch

Arduino Einsteiger Set

Arduino Einsteiger Set

73,00 EUR

Platine mit Lötpunkten RM2,54 100x100

Platine mit Lötpunkten RM2,54 100x100

1,19 EUR

Testkabel / Jumper Wires F/F 200mm

Testkabel / Jumper Wires F/F 200mm

2,75 EUR

Breadboard 830 Pin

Breadboard 830 Pin

4,50 EUR

Electronic brick - 125Khz RFID Reader

Electronic brick - 125Khz RFID Reader

0,00 EUR