Signalyzer ARM JTAG Starter Kit

Produktbeschreibung

Der Signalyzer ist ein USB Tool, welches als JTAG Intferface oder als USB -  SPI, I2C, UART Bridge genutzt werden kann.

Hierbei handelt es sich um ein Komplettset inkl.

• Signalyzer H2
• ARM JTAG Modul (Pegelwandler (2-5,5V, Powersupply 1-4,75Vmax. 500mA)
• USB Kabel
• 20 Pin JTAG Kabel

Signalyzer ARM JTAG Starter Kit. All you need to interface to a standard ARM 20-pin JTAG target device or board.

The kit package contains:

• Signalyzer H2 ( DT-USB-SH2 )
• ARM JTAG adapter module ( EM-ARM-JTAG )
• USB cable ( CBL-USB-A-MB-3 )
• 20-pin IDC cable, 10cm (4") (CBL-FC20-4)

Signalyzer H2 Features and Specifications

• Modular design approach for most flexibility
• USB powered
• USB 2.0 High Speed ( USB 2.0 up-to 480Mbit/sec)
• Dimensions: 45mm x 40mm x 13mm
• 2 independent configurable channels
• Up to 22 configurable GPIO lines per side
• 5VDC output with soft start, overcurrent and thermal protection (requires powered USB hub)
• Supports most popular Serial Protocols ( SPI, JTAG, I2C, UART ), support for additional protocols may be realized with Bit-bang modes.
• JTAG TCK up-to 30MHz with true RTCK support.
• Parallel interface modes of operation including High-speed FIFO, Asynchronous and Synchronous Bit-bang modes.
• 3 user controllable bi-color LEDs (RED / GREEN)
• 2 10-bit ADC Input per side
• 1 PWM output per side
• I2C bus for Accessory modules control and configuration
• GPIO is 3.0V - 5.0V capable. (GPIO voltage range can be expanded with use of variety of Accessory modules and can be expanded to 1.15V - 5.5V or fully isolated mode)
• 100mA power consumtion (without external connections or modules)
• Expandable with range of Accessory Modules
• Accessory Module type detection
• Field upgradeable firmware
• Two IDC 0.1" 26-pin dual row connectors.

ARM JTAG 20pin Level Translating Adapter Specifications

• Target voltage range: 1.65VDC - 5.5VDC
• 24mA output drivers
• JTAG TCK up-to 30MHz
• RTCK signal support
• ESD Protection Exceeds JESD 22
  – 2000-V Human-Body Model
  – 200-V Machine Model
  – 1000-V Charged-Device Mode

Compatible software

• OpenOCD (Open On-Chip Debugger)
• UrJTAG
• CrossWorks from Rowley Associates