USB-Host-Shield (SparkFun)

Produktbeschreibung

Das USB Host Shield erweitert das Arduino Board um einen USB Hostanschluss.


Vollständige Englische Beschreibung:

This new version corrects the pin out for the GPX and RESET pins. The USB Host Shield contains all of the digital logic and analog circuitry necessary to implement a full-speed USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB slave device - thumbdrives, digital cameras, bluetooth dongles, and much more!

A four-wire serial interface is used to communicate with the host controller chip, so the shield connects the Arduino's hardware SPI pins (D10-13) to the MAX3421E. A USB type A female connector is wired up to the IC, and it also supplies 5V as any normal USB port would.

The Host Shield takes its power from the 'Vin' pin on your Arduino. Power from that pin is regulated to both 5V and 3.3V on the shield. All SPI signals are sent through a hex converter to step them down to 3.3V.

Documents:

• Schematic
• Eagle Files
• USB Host Shield Projects/Code (Huge thanks to our friend Oleg!)
• MAX3421E Datasheet

Replaces: DEV-09947

DEV-09947