Proto-Shield Kit (Freeduino)

12,49 EUR

weight: 0.0300 kg

In stock: 3

Lagernd, gewöhnlich versandfertig in 24 Stunden.

Product.Nr.: 2009819

Product description

The Arduino Protoshield is a Shield board that sits on top of a standard Arduino board.

This design has a few good features:

power busses for +5V and GND in middle of board
central bus can be configured to carry +5V, GND, neither, both (jumpers)
Special horizontal 5-pin bus to install pin headers for external connections.
2x5 IDC connector area for external connections.
holes connected in groups of five, breadboard-style
all regular Arduino pins accessible on top
bottom of board cannot short to USB connector as in other protoshield designs
power LED and reset button on top
USB/External power jumper accessible with protoshield installed
low parts count: only one capacitor, a resistor, and LED and a switch, in addition to header pins.
two ways to use it: add header pins and a breadboard on top, or just use through holes to wire point to point.

Arduino Protoshield PCB
Parts	Qty	Device
PCB	1	Arduino Protohield PCB
Digital header	4	4-pin long legged female header
Analog/Power header	2	6-pin long legged female header
Reset	1	Tactile switch
Resistor	1	330ohm or 470ohm resistor
Capacitor	1	0.1uF ceramic capacitor
Selector header	1	6-pin male header
LED	1	3mm LED
Selector jumpers	2	Jumper or shunt
ICSP header	1	2x3 6-pin long legged female header

	Großes Arduino Einsteiger Set 99,00 EUR
	DS18B20+ 2,00 EUR - 1,80 EUR
	ePIR Bewegungsmelder 10,33 EUR
	Thumb Slide Joystick 2,89 EUR
	Kettensatz 7,65 EUR