GHI/FEZ Zubehör

Accelerometer Module

An accelerometer is an electromechanical device that measures acceleration forces. These forces may be static, like the constant force of gravity pulling at your feet, or they could be dynamic - caused by moving or vibrating the accelerometer.

11,81 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Barometer Module

This module is used for atmospheric pressure, altitude and temperature sensing . A sensor HP03M, which measures the pressure based on a piezoresistive pressure sensor, was equipped on this module, and provides accurate pressure and temperature data. -40℃~+85℃ operating range.

30,21 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Bluetooth Module

The Bluetooth module enables Gadgeteer mainboards with a wireless connection to connect to any other Bluetooth device with SPP (Serial Port Profile), such as mobile phones and laptops. This module can host a connection or search and hook onto other connections.

36,57 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Button

Connect this button to a digital pin to read its status. Additionally, the board includes a small LED that is automatically lit when the button is pressed.
The output of this component is low when the button is pressed and high otherwise.
It is connected through a standard JST3AA cable (included).

4,24 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Camera Module

This USB Camera Module can stream images as large as 320x240 with up to 20fps on smaller images.

30,14 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

CAN DW Module

Gadgeteer specifications include a CAN socket type which exposes the CAN TX and CAN RX digital lines. This leaves the option of selecting a transceiver up to the module. For example, this can be a High Speed Dual Wire, Single Wire or even Low Speed Fault Tolerant.

This module offers a High Speed, up to 1mbps, dual wire transceiver. The required 120ohm termination resistors are already included on the module but can be disconnected by desoldering the SMT jumper.

22,84 EUR incl. 19 % USt zzgl. Versandkosten

Nicht auf Lager

Cellular Radio Module

This module provides a way to use the GSM cell phone network to receive or send data . It allows the user to achieve this via three methods: Short Message Service, Audio and GPRS. It is configured and controlled via UART using simple AT commands.

63,99 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Compass Module

This module is designed for low field magnetic sensing with a I2C interface for applications such as compassing and magnetometry with 1°to 2°heading accuracy. It is Suitable for applications like navigation systems and consumer electronics.

14,55 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

eblock Kit

Save more than 50% for a limited time, and take advantage of this special eblocks kit and empower your gadgeteer mainboard with plenty of options.

53,94 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Ethernet J11D Module

This Ethernet Module gives a Gadgeteer mainboard an instant access to networks and internet. Not all Ethernet modules work on all boards. Make sure this module is compatible with your mainboard. This module is compatible with GHI's Spider mainboard.

14,50 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

FEZ Spider Mainboard

FEZ Spider Mainboard is a .NET Gadgeteer-compatible mainboard based on GHI Electronics EMX module. This makes FEZ Spider Mainboard the most feature-full .NET Gadgeteer compatible device in the market. It contains all of .NET Micro Framework core features and adds many exclusive features, such as USB host, WiFi and RLP (loading native code). All these features combine to provide a rapid prototyping platform.

118,95 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

FEZ Touch

2,4" LCD mit einer Auflösung von240x320 Pixeln.

34,70 EUR incl. 19 % USt zzgl. Versandkosten

Nicht auf Lager

GPS Module

This module includes a U-Blox Neo-6M GPS module and a simple patch antenna connected via a U.FI connector. The processor can communicate with this module via serial port. 1 to 5Hz update frequency. Supports NMEA and U-Blox 6 protocols. Configurable communication baud rates, from 4800 to 115200 External interrupt support

Requires socket Type U.

.NET Gadgeteer compatible cable is included.

44,85 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Gyro Module

Gyro module for Gadgeteer. This 3-axis MEMS motion processing gyro is a complete 3-axis angular rate measuring system. A 3-axis angular rate sensor was integrated in this small board. You can measure angular rate with the I2C interface. This module is suitable for motion detection and location detection.

Requires socket Type I.

46,68 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Joystick Module

This Joystick Module can measure position coordinates on the X and Y axis by moving the "hat". It also contains a switch that is press-able by pushing the "hat" down. Similar to what is used in the XBOX controller.

6,36 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

LED7R Module

The 6 Green LED's can be programmed to rotate,blink,alternate, or do whatever you like them to do. They can be used as indicators of level or speed. The center Red LED is also programmable and can be used to indicate some events.

6,36 EUR incl. 19 % USt zzgl. Versandkosten

Nicht auf Lager

Music Module

Turn your gadgeteer mainboard into an internet radio with a few lines of code. This module includes an audio decoder capable of playing MP3, WMA, OGG, MIDI and WAV files. All you need is to read the files from a storage device or network, and send it to the decoder, it does the rest. Audio quality is very high with a built in headphone audio-amplifier.

31,99 EUR incl. 19 % USt zzgl. Versandkosten

Nicht auf Lager

SD Card Modul

SD / MMC Kartenatapter für die GHI NETMF Boards.

5,99 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Serial-USB Module

Using this module, any of the serial UART sockets on a mainboard can be converted into a virtual serial connection over USB. Use this connection to transfer data to a PC or for debugging over serial (virtual serial over USB). This is useful when needing to free up the USB client port for other purposes, like simulating a mouse or keyboard on USB Client port.

19,78 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Smart Multicolor LED Module (DaisyLink)

This smart module includes a 32bit microcontroller. The stock firmware controls a bright multicolor LED (fade, blink,..) through .NET Gadgeteer DaysyLink protocol commands sent from .NET Gadgeteer mainboard. It also allows chaining with other DaisyLink modules. Advanced users may program or customize the on-board microcontroller.

13,75 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Taster Modul

Button Module for Gadgeteer-compatible devices. This module is equipted with an on-board configurable LED.

4,53 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Temp&Humidity Module

Temp&Humidity sensor module for Gadgeteer. This Module was equipped with a SHT11 sensor, which measures relative humidity and temperature, and communicates with the processor via a 2-wire serial interface. Besides, the small size and special PCB layout makes this module have ultra low power consumption and excellent long-term stability .

16,39 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

TinyCLR FEZ Cobra Gehäuse

Kunststoffgehäuse für das FEZ Cobra + 3,5" LCD, mit einer Modifikation passt auch das 4,3" LCD.

22,75 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

TinyCLR FEZ WiFi Erweiterung

WLan Erweiterung für die FEZ Boards auf Basis des ZeroG ZG2100 Modules.

83,95 EUR incl. 19 % USt zzgl. Versandkosten

Nicht auf Lager

USB Client DP Module

This module provides access to USB client connector and also includes an advanced power supply, allowing the mainboard to be powered from USB or from the power jack. Connecting power on both sides is safe. The power supply is fully functional from 7V to 30V supporting over 800mA of current.

21,51 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

USB Host Module

With USB Host support, developers are able to read a USB Joystick, Mouse and keyboard and are also able to save/read files off of a USB memory stick.

5,90 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

USBizi100 Chipsatz

USBizi™ 100 pin chipset is identical to the 144 pin version except it doesn't contain a USB host. USB device is still available and works exactly the same way.

USBizi LQFP100 (14x14 mm) chipset is based on LPC2387 from NXP.

14,40 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

WiFi RS21 Modul

Wlan Erweiterung für die GHI NETMF Boards.

91,49 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

WiFi-Ethernet Bridge

Go wireless with the same Ethernet port with this easy-to-configure Ethernet to WiFi Wireless bridge.

34,66 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.

Wii Controller Interface

Using this component, you can connect a Wii Classic controller or a Wii Nunchuk controller to a FEZ.
Connect to I2C SDA/SCL pins through the included JST3AA cables.

9,34 EUR incl. 19 % USt zzgl. Versandkosten

Lagernd, versandfertig in 24 Stunden.