RS-485 Breakout

RS-485 Breakout

8,71 EUR

incl. 19 % USt zzgl. Versandkosten

Gewicht: 0.0200 kg

Hersteller: SparkFun

Lagerbestand: 15

Lagernd, versandfertig in 24 Stunden.

Lagernd, versandfertig in 24 Stunden.

Art.Nr.: BOB-10124
RS-485 Breakout
     

Produktbeschreibung

Breakout Board mit dem SP3485 RS-485 Transceiver.


This is a breakout board for the SP3485 RS-485 transceiver IC, which will convert a UART serial stream to RS-485. The SP3485 is a half-duplex transceiver, so it can only communicate one way at a time, but it can reach transmission speeds of up to 10Mbps. This board requires a very low amount of power and can operate from a single +3.3VDC supply.

This breakout board includes the SP3485 RS-485 transceiver, filter capacitor, and other components shown on the schematic. We've broken out the RS-485 output to three different connections: (1) an RJ-45 connector, (2) a 3-pin 3.55mm screw terminal, and (3) a 3-pin 0.1" pitch header; none of these output connectors come populated.

Features:
  • Fully equipped with SP3485 RS-485 transceiver and supporting components
  • Operates from a single +3.3V supply
  • Interoperable with +5.0V logic
  • RS-485 input/output broken out to RJ-45 connector, 3.5mm screw terminal, and 0.1" pitch header
  • Driver/Receiver Enable connected to RTS line
  • -7V to +12V Common-Mode Input Voltage Range
  • Allows up to 32 transceivers on the serial bus
  • Driver Output Short-Circuit Protection

Dimensions: 0.9x1.0"

Documents:

Replaces: BOB-09823


Kunden kauften auch

Mega Proto-Shield nur PCB (Rev. 3)

Mega Proto-Shield nur PCB (Rev. 3)

8,00 EUR - 5,00 EUR

CP2103 Breakout Board - USB zu Seriell Wandler

CP2103 Breakout Board - USB zu Seriell Wandler

18,49 EUR

MicroSD-Sockel (Molex 492250821)

MicroSD-Sockel (Molex 492250821)

2,00 EUR - 1,85 EUR

FabScan-Shield - nur PCB

FabScan-Shield - nur PCB

2,98 EUR

RPi-Shield-Bridge (Raspberry Pi - Arduino Adapter)

RPi-Shield-Bridge (Raspberry Pi - Arduino Adapter)

17,95 EUR - 15,01 EUR