Assembly Guide - BOT116 Outputs PCB Panel

5,95 EUR

incl. 19 % USt zzgl. Versandkosten

Gewicht: 0.0380 kg

Lagerbestand: 25

Lagernd, versandfertig in 24 Stunden.

Lagernd, versandfertig in 24 Stunden.

Art.Nr.: BOT116
     

Produktbeschreibung

The circuit boards of the BOT116 Outputs Pack require a small number of components
to be fitted and a small amount of simple soldering. All components required are
supplied.

Assembly Instructions:
Carefully remove all PCBs from the panels by applying a gentle rocking motion to the
PCBs until they snap out of the panel. Note that in each case the bottom of the PCB is
marked with the gold text label (e.g. Piezo).

Piezo Module
Solder the piezo onto the PCB (either way around) and cut the legs short.

LED Module
Place the 33 resistor (orange orange black gold) over the black text on the board so that
the legs come out the solder pads on the bottom of the board. Resistors can be placed
either way around. Solder in position and cut the legs short.
Place the long leg of the LED through the ‘red’ hole on the PCB. Solder in position and

cut the legs short.

Transistor Output Module
Place the 100 resistor (brown black brown gold) over the black text on the board so that the legs come out the solder pads on the bottom of the board. Resistors can be placed either way around. Solder in position and cut the legs short.
Place the 1N4001 diode in position, ensuring the grey band marked on the diode lies over the black band marked on the PCB. Solder in position and cut the legs short. Place the BCX38C transistor in position, esnsuring the curved edge is marked as on the PCB (curved side towards the microbric connection points). Solder in position and cut the legs short. Snap the 4 way connector block in half to create 2x 2 pole connector blocks. Solder in position, ensuring the contacts face out.
If desired, screw the supplied buzzer into the terminal block, ensuring the coloured wires match the coloured markers on the PCB.

Motor Driver Module
Place the 16 pin IC socket on the top of the board (side without text).
Solder in position.
Place the 100nF capacitor in position and solder in place.
Place the 2 pole connector blocks. Solder in position, ensuring the contacts face the row of 4 identical holes.
Place the L293D chip inside the 16 pin socket, ensuring pin 1 is nearest

to the connector block.

1 PCB panel containing:
Piezo Output BOT116
Motor Driver BOT116
Transistor Driver BOT116
LED Output BOT116
1 100nF capacitor CAP001
1 4 way terminal block CON006
1 Yellow LED LED003
1 1N4001 Diode RES041
1 BCX38C Transistor TRT002
1 PCB Piezo SPE001
1 Resistor 33 RES-33R
1 Resistor 100 RES-100R
1 16 pin IC Socket ICH016
1 L293D motor Driver ICO030
1 Buzzer SPE005