Ethernet-Shield (WIZnet W5500)

26,18 EUR

incl. 19 % VAT excl. shipping costs

weight: 0.0700 kg

Manufacturer: WIZnet

In stock: 45

Lagernd, versandfertig in 24 Stunden.

Lagernd, versandfertig in 24 Stunden.

Product.Nr.: 20150188
     

Product description

W5500 Ethernet shield is designed using the WIZnet W5500 chip. Please click the link for the further information about W5500. It supports both 3.3V & 5V. This Ethernet Shield is compatible with Arduino and ARM mbed Platform.
Arduino Lib: <Ethernet2.h>

Available Board List

• ARM mbed Board
   - ARM mbed Platform : ARM mbed platform Site
   - FRDM-KL25Z : Freescale
   - NXP LPC800-MAX : NXP
 
• Arduino Board
   - Arduino board (e.g. the Uno, Mega, Due)
   - Arduino Leonardo
 
• Arduino-compatible Board
   - Seeeduino v3.0 : Based on Arduino Duemilanove

Feature
• Suppport 3.3V / 5V
• High Speed Ethernet controller W5500 chip
• SPI interface
• Internal 32Kbytes Tx/Rx buffer
• 10/100 Ethernet PHY embedded
• Support Auto Negotiation (Full / Half duplex, 10 / 100-based)
• Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
• User Selectable GPIO pin
• Support SD-card slot for storage
• Support I2C, UART interface

Hardware Configuration

• RJ-45 with Transformer : Ethernet Port
• W5500 : a hardwired TCP/IP Ethernet Controller
• RESET : Reset Ethernet shield and Arduino when pressed
• SD-Slot : support Micro SD card in FAT16 or FAT32 ; (Please Read the Caution)
• I2C : I2C interface
• UART : UART interface

Customers also purchased

Sharp GP2Y0A21YK0F

Sharp GP2Y0A21YK0F

10,57 EUR - 9,42 EUR

JST PHR4 zu JST PHR4 - 200mm für senseBox

JST PHR4 zu JST PHR4 - 200mm für senseBox

1,43 EUR

JST PHR4 zu Jumper Wire (Male) - 150mm

JST PHR4 zu Jumper Wire (Male) - 150mm

1,00 EUR

JST PHR4 zu JST PHR4 - 300mm für senseBox

JST PHR4 zu JST PHR4 - 300mm für senseBox

1,67 EUR